Axminster T-2000CK Instrukcja Obsługi Pobierz pdf (Strona 9)

Assembly Instructions

Step 4 Locate the angle brackets (6), place the bracket ﬂat

against the upper square tube (2), line up the pre-drilled

holes and secure with two button head bolts (f), see ﬁg

07. Repeat on the process for the opposite side and carry

on for the remaining legs.

Fig 07

Fig 08-09

Step 5 Locate the three cross support brackets (4), line up

the pre-drilled holes in one of the brackets with the holes

in two of the angle brackets (6), using four button head

bolts (f) and nuts (b) secure the cross support bracket

(4) in position. Repeat for the remaining two side of the

assembly. (see ﬁgs 08-09).

Step 6 Locate the three castor wheels (22), screw each

castor into the threaded holes on top of legs (3), using a

spanner tighen the nut at the base of each castor to lock

the assembly in position. (see ﬁgs 10-11).

Fig 10-11

Step 7 Locate the extraction drum (7) and the 12unc

Hex screws (a). Position the drum on top of the motor

assembly (1), there are arrow marker labels on each unit,

line up these labels and secure the drum (7) to the motor

assembly (1) using the Hex screws (a). (see ﬁg 12-13)

Fig 12-13

Locking Nut

Arrow marker label

Step 8 Loosen clamping bolt/nut from the extention

funnel (11), remove the clamping ring and place safely

aside. Lower the wide end of the funnel (11) on top of

the drum (7) and line up the rims. Locate the clamping

ring you removed earlier, position the ring over the

rims and tighten the bolt/nut to lock both units (7-11)

together. (see ﬁgs 14-15).

Continues Over...

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 25 26

Brak uwag

Axminster T-2000CK Instrukcja Obsługi Strona 9