Axminster AW10BSB2 Instrukcje Operacyjne Pobierz pdf (Strona 23)

Initial Assembly

Lower the fence mounting (43) onto the rear quadrant NOTE: position the fence so the sacriﬁcial

plastic orange tongue is against the table to the right of the mounting. Position the fence so

when it is pivoted it will not encroach into the saw slot. Lightly tighten the two caphead bolts on

the fence mounting (43). Replace the clamping handle and washer you removed earlier. (See ﬁg

77)

Screw the post into the tapped hole in the

sliding table (38)

Fitting the workpiece hold down clamp

onto the main tool post

Fig 78

Fig 79

Introduce the Tool Post (37) through the table fence mounting (43) and screw the post into the

tapped hole in the sliding table (38) (See ﬁg 78). The post is shouldered so it holds the Fence

Mounting in position against the table. Fit the workpiece hold down clamp onto the main tool

post and pinch up the clamping knob, see ﬁg 79 and tighten the caphead bolts on the table fence

mounting casting. (43) (See ﬁg 80) Mount the distance stop (46) by introducing the square clamp

into the wide channel in the top of the fence extrusion and clamp it in position using the lever

handle. (See ﬁg 81-82) Sliding table assembled. (See ﬁg 83)

Fig 81

Fig 82

Fig 83

Fig 80

Square clamp

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 51 52

Brak uwag

Axminster AW10BSB2 Instrukcje Operacyjne Strona 23